3D-Gloss Sealer 20 Litre ph11
Description
Sealers protect surfaces by establishing a barrier to try to resist chemicals, stains, and rough contact.
Surfaces need to be prepared before a sealer can be applied. On new surfaces, they just need to be cleaned, and then instructions followed on laying sealer. On older surfaces, it may be necessary to strip the old sealer off, to clean well, as a new sealer just creates a clear layer embodying all old established seals and stains. Look at our blog on stripping and sealing
Agar 3D-Gloss 20L
With a fast cure rate, making it ideal use for high-traffic locations.
3D Gloss provides a crystal clear dazzling gloss.
3D Gloss is a super glossy sealer with premium ingredients suitable for:
- Vinyl tiles
- Sealed timber
- Sealed terrazzo
- Sealed marble
- Terracotta
- Slate
- Linoleum
- Brick floors
Key Benefits:
- When sealed with 3D gloss floors will sparkle
- Non-Slip
- Scratch repair ensures stays shiny for longer
- Responds to both gas and electric buffing machines
Application
- Remove adhesive, build-up sealer or wax, and other soilage. New floors should always be stripped prior to sealing. Whilst a new floor looks clean, it is covered in a protective film added at the time of manufacture. New floor sealer will not adhere to this film, so it must be stripped.
- Flood-rinse floor to remove the stripper and dirt. The floor must be well covered in clean water. Mop up or wet-vac and allow to dry. If floor is vinyl, burnish floor then fringe mop to remove dust. Do not burnish bare terrazzo or stone floors.
- Apply basecoat sealer using a fringe mop or bucket mop. On vinyl tile floors that take heavy traffic, 2 coats are recommended. On terrazzo, marble, and polished concrete, one coat of FIRST BASE must be applied to seal the floor. Check that the basecoat/s are tack-free and dry before applying 2 or 3 coats of 3DGLOSS, making a total of 4 coats.
- After 2 to 7 days, apply 2 more coats of 3D-GLOSS. This film of 6 coats will provide a sound foundation for protecting the flooring and will give an excellent depth of shine.
- For the first week, soft buffing pads (such as champagne) must be used. After this period, Jackeroo Lite or other UHS pads can then be used for burnishing.
- Maintain floor by cleaning with AUTOSCRUB then dry buffing or spray buffing. Softer pads with no natural hair fibres are preferred.
- Re-coat heavy traffic areas when required. This will ensure a shiny, beautiful, and long-wearing coating.
- Worn films may be scrubbed off using FLORPREP at 1:20 with blue pads and may then be recoated with 3DGLOSS after buffing and sweeping.
- Do not apply any sealer to a very cold floor (9ºC or less). If application is unavoidable in very cold or humid weather, lay very thin coats one hour apart.
Also available in 5L.
Safety Data Sheet
